Clearaudio ANNIVERSARY Manuale Utente Scaricare il pdf (Pagina 5)

nniversar

User manual / Bedienungsanleitung

Page / Seite 5  clearaudio electronic GmbH 2008

2. Assembly and Operation

First please put on the white gloves to avoid finger prints on the surface of the

acrylic chassis during installation.

1. Place the chassis on a solid and low resonance base. The base should be levelled

before. To protect the surface of the chosen rack, simply use the delivered flat pads

placing them under the spikes of the turntable chassis.

2. Unpack the turntable platter with the upper part of the platter bearing. Remove

the protective security tape from the bearing housing and place this unit carefully

over the spindle mounted in the turntable chassis. Do not use too much pressure for

this step otherwise you will cause damage to the bearing.

Caution: pay attention not to place any of the grease on the acrylic surface of the

chassis. Be sure that the two markings (platter, upper part of the bearing shown in

pic. 2) are positioned as shown in the figure.

3. Place the pulley on the motor spindle. The distance between the pulley

and the motor housing should be approx. 1-2mm. Tighten the little screws

inside the pulley with the aluminium screwdriver provided (pic. 3).

4. Place the stand alone motor on the top of the motor stand on

the position as shown in the right figure. The power switch on the

upper side of the motor should show to the outside and the pulley

to the turntable platter. The distance between the motor chassis

and the turntable platter should be approximately 2 cm (ca. ½

inch) (pic. 4).

Picture 1: Placing the platter

Picture 2: Markings of the bearing

Picture 3: Pulley on the motor

Picture 4: Placing the motor

1 2 3 4 5 6 7 8 9 10 ... 15 16

Nessun commento

Clearaudio ANNIVERSARY Manuale Utente Pagina 5